Roofing in Melbourne

Getting set up on a job

Access made easy with the high lift truck

Whether it is pavers or concrete, we can protect your driveway

Having the right equipment makes the job easier, we also use a 12 ft dump trailer, a 45 foot conveyor, and many other job specific tools for almost any roofing job

Cupola Repairs

Or "Don't let the Rain Come In "

Water was entering through this large cupola on a local golf course clunhouse

this is what we found when we removed one of the louvers, the metal diverters had failed. Cause of this event? most likely electrolysis between dissimilar metals (copper and steel)

we removed the old diverters, installed a self adhesive flashing tape to separate new aluminum diverters and the existing copper pans



New custom made .032 aluminum diverters installed

louvers installed and caulked

How do you know when to replace your roof?

The answer to that question is multifaceted. Leaks in the roof, age of the roof, and cost is a big factor.
Leaks in the eaves can damage plywood, fascia, soffit, and trusses.

no leaks in the house, plenty at the edges

this type of leak is caused by improper application (workmanship)

 Leaks in the home can do similar wood damage and also create serious health issues with possible mold growth. Repairs to older roofs can be difficult and that would be part of the equation

Do you think they waited too long?

this looks right into the kitchen

about three days of wood work

another issue that we can look at in the next blog will be: Should I wait for a storm to blow off my roof so the insurance company will pay for it?  DUH

West Melbourne FL re-roof project

We installed Landmark Pro shingles (50 squares plus) on this house in West Melbourne. It also had 7 squares of flat roof, where we install 1/4" tapered insulation.

The chimney was cleaned and sealed, new .032 aluminum flashings, replaced cricket

                                                                It finished up nicely

Indian Harbour Beach Reroof

Double layer of shingles hides a lot

This is the result of putting shingles on a roof below 2"/12"
not once, but twice! two layers.



Certainteed makes modified bitumen flat roof material to match the shingles. End result, a nice roof.

Roof to Wall connections are important

Most homeowners on the barrier island know how expensive home owners insurance is. any discounts and credits that are available may be worth pursuing.

Typical single wrap strap needed nails added to qualify for insurance discount

Removing 1x12 decking over the walls exposes the straps for nailing

single wrap strap

plywood installed over 1x12 makes for a great substrate for shingles

we used Resisto shingle underlayment, a self adhesive modified bitumen, Certainteed Landmark Pro shingles and Stainless Steel roofing nails

J.K. Behan Float in the 2014 St Paddy's Day parade in downtown Melbourne

I almost forgot to post a picture of this year's St Patrick's Day Parade
To my friends and family "thanks for all the help"

Grant Valkaria Roof replacement

Setting up the safety equipment takes some time but pays off with production

 6 foot pipe scaffold with aluminum planks and hand rails, harness and lanyard up top


Roof jacks with hand rails

Breaking down the scaffold and  jacks goes quick with many hands

.032 aluminum flashing on chimney

                             This roof was an 8/12 slope, some of it two story, done in 5 days

heading back to the shop

Re-roofing has been as busy in January and February as I have ever seen it

Pompano Dr Melbourne Beach

next door to Gemini School



This chimney leaked for years

another flat roof with issues

Completed Project in Melbourne

I have been too busy to put a new post on our blog, knock on wood. We hired a couple of good roofers to help with the work load, hope this is a sign of how this year will go. We've done about six jobs so far this year, and had maybe eight rain days.
And the wood floor project in my own house is finally to where I can see light at the end of the tunnel!

Melbourne Florida re-roof

Lamanco 40 Watt solar attic vent

Just about done

two new 2x4 Sun-Tek Impact Resistant Glass Skylights

The Homeowner wanted to get his solar heater for the pool replaced and the skylights replaced, snowballed into a whole new roof.. Thank you Milt!

Indialantic by the Sea repairs on Eastminster Presbyterian Church

Leaks at the fascia

Leaks at the valleys

Priming the new fascia

 

Ready to shingle

My Way - My Page

J. K. Behan Roofing
Before: preparation of the gas vent, care must be taken not to move the gas vent out of position
After: roof touch up paint adds that detail that makes the job complete

This was direct quote from this Angie’s List customer:   “I saw only  a couple of reviews that had some negativity. I've been in the contracting business for 45 years and I can assure you Jim Behan has more integrity and knowledge of his business than one could hope for. He manages a great crew, respectful of the homeowner, his property, etc. I would recommend him to anyone I know, friends and family alike. If your looking for a source make sure you talk to Jim if you want a really dependable contractor. No short cuts, he makes sure you get a really quality job.”  Robert B. Suntree subdivision, Melbourne, FL

Melbourne Re-Roof

International High Lift Truck makes work much easier

Suntree Re-Roof, 38 squares of shingles replaced, new plywood installed over exposed 1x12

Proper spacing is essential when installing plywood, 1/8" is recommended. reduces chances of "picture framing", warping, or buckling caused by movement (thermal or moisture can cause this)

This upper photo is actually the "after", below is the "before"



It is easy to see why 1x12 lumber does Not make a good base for shingles (or much else)
 

St. Patrick's Day 2013 Parade

Behan's Traditional Irish Cottage

Thanks to Mike Smith, he sent me this picture he took of our float in the AOH St. Patrick's Day Parade in downtown Melbourne, March 16, 2013.

Look close and you see my beautiful wife Karen, with the cowboy hat, and Quinn, the yellow lab, laying at her feet

Also there but not shown, my daughter, Tara and her husband, Brendan. They looked great. Handing out candy, they could hardly keep up!

We had about three days of labor, constructing the cottage. Based on an image found on the web, we tried to simulate the slate roof with Certainteed Presidential shingles, custom fabricated aluminum drip edge and copper ridge cap. The chimneys would have allowed for a dry ice "smoke" if we had had the time to get it together. Thanks to all who had a hand in it!

J. K. Behan